Editing Script Block (section)

== Inputs and outputs ==

The inputs and outputs are all referred to by the letters N,S,E,W,U,D for north, south, east, west, up and down. The N,S,E,W are shown on the chip itself, the up and down you’ll just have to figure out for yourself.
You can set a direction equal to a value and that value will be output to that directions. e.g.

<pre>N = 5</pre>

or

<pre>W = 'Hi there'</pre>

You can output to multiple directions in a single program

<pre>N = 5
W = 'Hi there'</pre>

You refer to the inputs in the same way, so say you have a number inputted in the West port and wanted North to be twice the West value you could use the following script

<pre>N = 2 * W //note that * means multiply</pre>